Iterative testing and revision
Start with a question about the stated system, then distinguish a measurement or observation from an explanation. A revision is evidence-based when a specific observed limitation motivates a targeted change followed by retesting. Record the original result, one change, and the comparable retest outcome. Record the evidence beside your claim so another learner can trace the connection. Compare a second possibility before deciding. State a limit: a small record, one perspective, or a simplified model rarely establishes every possible case.
A worked example
Worked investigation: A paper glider turns sharply because one wing is bent. A supported response is: Adjusting that wing and repeating the same launch can test the explanation.. Reasoning: A revision is evidence-based when a specific observed limitation motivates a targeted change followed by retesting. This conclusion applies to the supplied situation; it does not establish every possible case. Weekly observation or model protocol: Build a paper bridge between two supports a fixed 10 cm apart, using one sheet for a flat design and one for a folded design. With adult-approved small counters, add equal loads gently and stop before anything falls beyond the contained workspace. Test each design three times, recording load held and where bending begins. Paper-only supplied model record: flat design holds 4, 5, 4 counters; folded design holds 8, 7, 8. Compare all values, revise one feature, and state the narrow conditions under which the comparison is useful.
- Build an investigation page for iterative testing and revision. Read the supplied scenario, sketch the system, and list three observations separately from explanations. Record the original result, one change, and the comparable retest outcome. Write a prediction that could be checked and note any safety or material limits. Set up the concrete observation or model protocol printed in the worked example and save the starting record.
- Construct a labeled paper model of the original scenario and a contrasting condition. Record the original result, one change, and the comparable retest outcome. Make an observation table with columns for condition, what changes, expected observation, and possible uncertainty. If an adult approves a safe physical version, keep every original model and record. Follow the printed protocol; enter actual observations or explicitly labeled supplied model data, preserving units and conditions.
- Compare the model conditions in three repeated trials or three carefully traced model runs. Record every result, including unexpected outcomes. Complete the practice questions and revise one model label so it distinguishes observed information from a proposed mechanism. Use the protocol’s repeated records and compare every trial; never invent a measurement to make the pattern cleaner.
- Add a new condition to your own model of iterative testing and revision, changing only one important factor where practical. Predict the effect before tracing or testing it. Compare the new record with the original conditions and explain what the comparison can and cannot establish. Revisit the same observation or model on a later day, preserving the original record and marking exactly what changed.
- Create a claim-evidence-reasoning display using your model drawings and all three repeated records. Record the original result, one change, and the comparable retest outcome. State one limitation, one justified revision, and a question for a later investigation; then attempt the reserved independent check without feedback.
Open the printable learning material